InteliGen NT Auto Mains Failure control module Static battery charger Emergency stop push button and fuses for control circuits

Comonents installed in sheet steel enclosure.
Phosphate chemical, pre-coating of steel provides corrosion resistant surface
Polyester composite powder topcoat forms high gloss and extremely durable finish
Lockable hinged panel door provides for easy component access

Control panel is mounted generating set baseframe on robust steel stand or power module. Located at side of generating set with properly panel visibility.

195Vac to 264Vac input volt-age range
 
45Hz to 440Hz input supply frequency range
 
Capability to work direct from 240Vdc to 365Vdc sup-ply voltage
 
27.6Vdc factory set DC out-put terminal voltage (option up to 29.4Vdc)
 
5.0Adc continuous output current into load
 
Capability to work continu-ously into short-circuit
 
Parallel connection for higher output current rating and redundant operation
 
Series connection capability for higher output voltage requirements
 
No cooling fans used for high operational reliability
 
Aluminum alloy case for ro-bust handling and easy mounting
 
STANDARD SPECIFICATIONS

• Comprehensive gen-set controller for both single and multiple gensets Parallel operation up to 32 gen-sets operating in standby or paralleling modes
• To be used in conjunction with detachable colour displays InteliVision 5 or InteliVision 8
• Support of engines with ECU (Electronic Control Unit)
• Complete integrated gen-set solution and signal sharing via CAN bus – minimum external components needed
• Many communication options – easy remote supervising and servicing
• Load sharing and VAr sharing via CAN   Virtual shared inputs and outputs via CAN   Support of wide range of applications
• Single or multiple gen-sets in parallel to mains operation with automatic back up function, multiple island operation
• Advanced power management function
• Customizable load control in parallel to mains
• Wide range of ECU support
• Highly configurable
• Timers, Internal PLC, Force values and more
• Active e-mail messaging and SMS with optional communication module
• Stop, Manual, Automatic, Test, Start, Silent / Lamp test,
• Automatic synchronization and power control AMF function, Baseload, Import / Export, Peak shaving, Voltage and PF kontrol (AVR)
• True RMS (TRMS) is used with Voltage, Current and Power measurement

EBC 2405M is designed and opti-mized for charging all types of Lead Acid batteries (including jell type sealed Lead Acid batteries), protecting the battery and extend-ing its useful life time
EBC 2405M can deliver continuous charging current of 5A into 24V battery system (voltage is set to 27.6Vdc, with an option of up to 29.4Vdc) These battery chargers are designed with performance in mind and special care is taken for protecting and extending the life-time of the battery.
 
EBC 2405M is designed with “Switched Mode” technology, where the switching transistor has only two states, ON or OFF, which increases the overall efficiency, hence reduces the excess heat dissipation and in return, increasing the device life-time and reliability.
 
The control system is also designed in such a way that; battery is charged in three stages:
 
Constant current mode (protecting battery cells)
 
Constant voltage mode (reducing the charge current)
 
Float charge (compensation of internal self-discharge)
 
Constant current mode makes sure that; when the battery is drained down below its rated capacity, the high charge current flow into the battery is limited in order to protect the cells and reduce damage to the plates.
 
As the battery capacity is recovered, each cell voltage reaches up to 2.30Vdc to 2.45Vdc level, which means that the required charging current starts to reduce.
 
When the required battery terminal voltage is fully reached, the charger keeps supplying just enough current in order to compensate for the internal self-discharge (float charge). This ensures that the battery can maintain its high charge state and deliver its rated out-put current, when ever required.